AMC-CAN4 - ESD AMC-CAN4 Expansion Module - Cost effective: 4 channels onboard,...
- Part Number:
- AMC-CAN4
- Model Number:
- AMC-CAN4
- Make:
- ESD
- Lead Time:
- Available
- Qty In Stock:
- Available
ESD AMC-CAN4 Expansion Module - Cost effective: 4 channels onboard, Wide software support: drivers for Windows, Linux, QNX and other operating systems Simple Type: Expansion Module
The AMC-CAN4 features four CAN High-Speed interfaces according to ISO 11898-2. The CAN interfaces are electrically isolated against the controller potential and against each other. CAN status is displayed by two LEDs for each CAN channel placed at the RJ45 connectors. The four independent CAN nets according to ISO 11898-1 are driven by the esd Advanced CAN Core (esdACC) CAN controller implemented in the Xilinx Spartan 3e FPGA. Controlled by the FPGA the AMC-CAN4 supports PCI bus mastering as an initiator, meaning that it is capable of initiating write cycles to the host CPU’s RAM independent of the CPU or the system DMA controller. This results in a reduction of overall latency on servicing I/O transactions in particular at higher
For Resellers and High Volume Orders:
Please request a quote to obtain preferred pricing.
Features
- 11-Bit and 29-Bit CAN IDs
- Acceptance filter (4-byte code, 4-byte mask)
- Arbitration lost interrupt with detailed bit position
- Automatic bitrate detection (software supported bit rate detection)
- Bitrates from 10kbit/s up to 1 Mbit/s supported
- CAN ISO 11898-1 protocol compatibility
- Complete access to CAN error counters
- Error code capture register
- Error interrupt for each CAN bus error
- Listen only mode (no acknowledge, no active error flags)
- Programmable error warning limit
- Receive buffer (64 CAN messages *)
- Self reception mode (Reception of ‘own’ messages)
- Single-shot transmission (no re-transmission)
Specifications
- Ambient temp.: 0 ...+70 /C (free convection)
- CAN connector: 4x RJ45, pin assignment acc. to CiA DR303-1
- CAN controller: esdACC in FPGA Spartan 3e, acc. to ISO 11898-1, (CAN 2.0 A/B)
- Connectors: J1: AMC B/B+ compatible (MicroTCATM)
- Dimensions: mid-height, single-width (73.5 x 180 mm) AMC
- Humidity: max. 90 %, non-condensing
- IPMI: IPMI V1.5, controller Atmel AVR
- LEDs: blue (hot plug), red (IPMI), green (OK), 4x yellow and 4x green (CAN status)
- mTCA: PICMG MTCA.0 R1.0, PICMG AMC.0 R2.0
- PCIe bridge: PCISIG PCIe spec. R.1.0a
- Physical interface: 4x CAN high-speed interface acc. to ISO 11898-2, electrically isolated, bit rate up to 1 Mbit/s
- Power supply: 3.3 V (I3.3VMPMAX- 70 mA), 12 V (I12VTYPICAL -0.4 A, I12VMAX- 0.5 A)
- Updates: PICMG HPM.1 R1.0
Applications
- None Available
Aliases
- None Available
Related Items
AMC-ADIO24
ESD AMC-ADIO24 I/O Module - The eight over voltage protected
AMC-ADIO-Adapter
ESD AMC-ADIO-Adapter I/O Module - HF ferrites in the